removing lower arm
#1
Full Member
Thread Starter
Join Date: Dec 2005
Location: Irvine CA
Posts: 165
Likes: 0
Received 0 Likes
on
0 Posts
removing lower arm
Im disassembling my front suspension, and have run into a problem, my brake assembly/entire knuckle is stuck on the lower arm. i looked in the fsm, it says to use the mazda sst, but i dont have one... any suggestions?
#2
Senior Member
Join Date: May 2002
Location: San Diego, CA
Posts: 266
Likes: 0
Received 0 Likes
on
0 Posts
I had this problem when I was installing front LCA bushings. What you will need is a ball joint remover to separate the two. If you plan to separate it yourself, make sure you don't mess up the rubber grease cups or you will have to buy a new front LCA as the grease cups aren't sold separately. That, or just bring the entire LCA assembly to any auto repair shop and they'll most likely be able to separate them or you.
Thread
Thread Starter
Forum
Replies
Last Post
KAL797
Test Area 51
0
08-11-15 03:47 PM