Ms02 Construction
#2
RX-7 Bad Ass
iTrader: (55)
It's typically pretty obvious if you look at a wheel that's a 2- or 3-piece. The bolts will go all the way through and aren't just stuck on, you can see the pieces of the wheel if you study the wheel, etc.
I do think, if memory serves, most Mazdaspeed wheels were multi-piece.
Dale
I do think, if memory serves, most Mazdaspeed wheels were multi-piece.
Dale
#4
Ms02
Yeah it was. The lips was machined. The reason I brought it up is because Im planning to chemically stripped it but I didnt go that route since I am not sure if its press fit or did Rays added glue in it. It might weaken the rims if that was the case.
#5
RX-7 Bad Ass
iTrader: (55)
Hell, just use some aircraft stripper on it. That will get the old finish off but won't stick around long enough to damage any adhesive that's in there. Spray on, let sit, scrub, hose off. It's better than dunking in a chemical vat or something.
Dale
Dale
Thread
Thread Starter
Forum
Replies
Last Post
HOZZMANRX7
2nd Generation Specific (1986-1992)
12
08-10-02 10:15 AM