Lowering the 7
01-10-05, 02:31 PM
#1
Senior Member
Thread Starter
iTrader: (2)
Join Date: May 2004
Location: Ohio
Posts: 463
Likes: 0
Received 0 Likes
on
0 Posts
Lowering the 7
I just bought a set of 275/50/15's BFGoodrich tires for my rear end and i need to now lower the rear b/c it sits a little too high.....i was wondering if i have to go about and buy all new suspension...or can i just take out the coil and cut it a little and then cut out the wheel well to sit the tire under my wide fenders....if anyone has any advice on this situation plz post b/c im getting ready to travel across the US and i dont really want my front end so close to the ground that i become a damn snow plow.....thanks...parker
01-10-05, 03:16 PM
#2
Rotary Freak
iTrader: (6)
Join Date: Jan 2002
Location: Golden, CO
Posts: 1,807
Likes: 0
Received 0 Likes
on
0 Posts
Please don't cut the springs, that's not the way to go about doing it. I don't know much about FB suspension options, but I would suggest looking into a new set of springs for the whole car, not just the rears.
01-10-05, 07:07 PM
#3
Senior Member
Thread Starter
iTrader: (2)
Join Date: May 2004
Location: Ohio
Posts: 463
Likes: 0
Received 0 Likes
on
0 Posts
well im going to be purchasing a set of Tokico Blue's (in about 2-3 months)...but until then i need to lower the car badly....and i also need to remove the inner wheel well so that i can tuck the tires....is there any other way i can go about it without buying all new suspension....thanks parker
Thread
Thread Starter
Forum
Replies
Last Post