Grinding noise from new brembo rotors
#1
Full Member
Thread Starter
Join Date: Mar 2001
Location: Houston Texas
Posts: 95
Likes: 0
Received 0 Likes
on
0 Posts
Grinding noise from new brembo rotors
I just installed new brembo rotors all around and ceramic brakes in the front on my FD. The tire does not roll freely when I jack up the tire, and when I turn a corner it maks a little grinding noise. What could be the problem?
#3
Yup, you swapped the two bolts that hold the front caliper on. Very common problem -- many of us have done that before. Swap the bolts back as soon as you can (don't drive it if you can avoid it) so you don't wear a groove into the inside face of the rotor.
-Max
-Max
#4
Full Member
Thread Starter
Join Date: Mar 2001
Location: Houston Texas
Posts: 95
Likes: 0
Received 0 Likes
on
0 Posts
boy if it wasent for my buddy's on the forum, I dont know what I would do. You all just save me from cusing out the owner of the store. boy would I have been wrong. Does the swaping of the bolts work the same way on the rear?
#5
Full Member
Thread Starter
Join Date: Mar 2001
Location: Houston Texas
Posts: 95
Likes: 0
Received 0 Likes
on
0 Posts
Yep you guys were right. I took the wheel off and what do I see? The bottom bolt grinding on the inside of the rotor. I switched the bolts and it did the trick. Can you beleive the guy that installed the rotors worked for mazda?
Thread
Thread Starter
Forum
Replies
Last Post
REX7&Z32TT
New Member RX-7 Technical
5
09-09-15 05:16 AM
83revival
New Member RX-7 Technical
4
09-03-15 10:42 PM