Another fitment for the FC .... :)
Another fitment for the FC .... :)
17x 8.0+9 17x 9.0 +17 5x114.3
Thoughts?
I think the front would stick out past the fender slightly? And the rear would be pretty flush if im not mistaken.
Thoughts?
I think the front would stick out past the fender slightly? And the rear would be pretty flush if im not mistaken.
What look are you trying to pull off? Grip? Stretched?
I'm assuming grip, because you wouldn't be able to stretch a tire very well on a 8" wide wheel. If that's the case, they would be a little more on the aggressive side, and would need at least a fender roll and some camber.
So if you're willing to roll the fenders and you have camber plates, they are workable.
Those sure are pretty
Also, some 225/45 for the front and 245/40 for the rear should look good...
I'm assuming grip, because you wouldn't be able to stretch a tire very well on a 8" wide wheel. If that's the case, they would be a little more on the aggressive side, and would need at least a fender roll and some camber.
So if you're willing to roll the fenders and you have camber plates, they are workable.
Those sure are pretty

Also, some 225/45 for the front and 245/40 for the rear should look good...
Heres alittle info i just found out. if you have super angle inner tie rods an 17x8.5 et28 will fit without rubbing at lock and may require a small fender roll. so those will be pretty close as well
Thread
Thread Starter
Forum
Replies
Last Post
Turblown
Vendor Classifieds
12
Oct 17, 2020 03:25 PM
jim_chung
1st Gen General Discussion
10
Oct 4, 2015 09:09 AM



