alignment cause bad handling?
01-02-11, 09:54 AM
#28
Yeah, shutup kid.
http://www.familycar.com/alignment.htm has some basic explanations. If you draw a line through the upper and lower ball joints, or upper spring perch and lower ball joint on a McPherson strut, the difference between where that line hits the ground and the center of the tire is the scrub radius. Where this line hits the ground is the point that the weight of the car is actually being applied. In short if you move this point too far away from the center of the tire bad things happen 
01-02-11, 02:56 PM
#29
Moderator
iTrader: (3)
Join Date: Mar 2001
Location: https://www2.mazda.com/en/100th/
Posts: 30,832
Received 2,602 Likes
on
1,846 Posts
well...the car tracks alot?? i think thats how to explain it...if im driving straight its horrible about following the lines and dips in the road, to the point where it trys to take you off the road alot....im not losing grip in the corners, the car just feels un willing to go aggresively around a corner.... my car only has 97k original miles and the suspension is tight...the car handled great with stock everything...now i have new wheels and coilovers and took the p/s of the car and it got alot worse
try putting the stock wheels on and see if the straight line tracking gets better.
01-02-11, 07:03 PM
#30
Auto Love
Join Date: Aug 2010
Location: NY
Posts: 14
Likes: 0
Received 0 Likes
on
0 Posts
good info here. I would also check the toe settings. toe out will cause the car to wander when driving straight. also, sluggish response can be related to tire pressure, higher increases response and lowers grip (at least thats the trend).
Unless something is physically wrong with your suspension, caster should be fine as caster is typically not adjustable, at least not stock.
Unless something is physically wrong with your suspension, caster should be fine as caster is typically not adjustable, at least not stock.
01-02-11, 11:02 PM
#31
car didnt come stock with factory wheels..off set is 30 front 30 rear....also i read that when installing coilovers you should have 1" of preload...so thats where i set mine when i installed them...now im reading that you should just tighten the spring perches untill the spring is snug and not run preload on a street car...would me running that much preload cause problems...also my car is kinda bouncy im thinking this is due to the preload??
thanx for all the responses!!
thanx for all the responses!!
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM
erevos
2nd Generation Specific (1986-1992)
4
09-15-15 09:19 AM
