28" Tall ET Streets, Will they fit
#1
Full Member
Thread Starter
Join Date: Nov 2001
Location: Green Oak,MI
Posts: 213
Likes: 0
Received 0 Likes
on
0 Posts
28" Tall ET Streets, Will they fit
I plan on using some 28" tall ET Streets on a 16" rim.
Will the fit?
Will a stock rim work or should I try one that tucks in a bit more?
Thanks
Will the fit?
Will a stock rim work or should I try one that tucks in a bit more?
Thanks
#4
Full Member
Thread Starter
Join Date: Nov 2001
Location: Green Oak,MI
Posts: 213
Likes: 0
Received 0 Likes
on
0 Posts
I can't run the 26", it ends up being too much gear. I have an LS1 conversion and 4th ends at 114 with a 26" tire, 28"'s get me 122.
Mine is an R1, thats lower than stock...Hoosier makes a QTP 27" tire.
How much lower is an R1 than a Touring?
Mine is an R1, thats lower than stock...Hoosier makes a QTP 27" tire.
How much lower is an R1 than a Touring?
#5
Lives on the Forum
Join Date: Dec 2001
Location: San Lorenzo, California
Posts: 14,716
Likes: 0
Received 8 Likes
on
8 Posts
An R1 is the same height as a touring. The T56 6-speed has 4th topping out at 114? That seems strange. Perhaps you need a higher rear-end ratio. Are you still running the stock FD rear end (4.1:1)?
#6
Full Member
Thread Starter
Join Date: Nov 2001
Location: Green Oak,MI
Posts: 213
Likes: 0
Received 0 Likes
on
0 Posts
Yep, running the 4.11.
I'm going to switch over to Jimlab's Cobra diff setup and go down to a 3.27 or 3.55.
I just raised the rev limited 400rpm, so that'll give a few more. I figuire the car will run 116-118, as long as I can just squeeze it in that would be cool.
I'm going to switch over to Jimlab's Cobra diff setup and go down to a 3.27 or 3.55.
I just raised the rev limited 400rpm, so that'll give a few more. I figuire the car will run 116-118, as long as I can just squeeze it in that would be cool.
Thread
Thread Starter
Forum
Replies
Last Post
Frisky Arab
2nd Generation Specific (1986-1992)
13
08-18-15 05:30 PM