i just hooked up my SAFC 2 2day and its wired right i'm pretty sure. i looked over it a few times. i start my car after its all hooked up. starts up fine so i take it on a test drive and when i give it mroe gas it falls on its face. i was goin threw the monitor section and the air gauge read at 100% but my car isn't on and my thr is at 0. if someone could help me and get a default stage until i get it tuned that will help out alot.
if not i'll jus unhook it and get it put in when i get it tuned.
my mods are 2.25 header, straight pipe to RB mufflers.
msd ign, intake cone slap
thats all as of now

 

get rid of the msd. and do the sensor check you r manual will tell you how to do that and work with the correction and check your timing

 

Well it could be a wire not hooked up right. Make sure the in out settings are correct for your model. Check the ECU wire code and make sure you have the right wires spliced. Make sure the throttle isn't hooked up to rpm and so on. Then double check everything again.

 

do both the AFM wires go in the same place cuz i'm goin off the diagram off 1300cc.com and theres 4 spots were u say 2 splice it in but theres 7 wires. the only question on wires for me is the air flow meter wires.

 

my bad i figured it out i jus can't tune it lol