Super AFC AFM Flap all the way open.. AFC says 80%!?!
01-13-05, 11:29 AM
#1
Junior Member
Thread Starter
Join Date: Nov 2004
Location: Las Vegas
Posts: 48
Likes: 0
Received 0 Likes
on
0 Posts
AFM Flap all the way open.. AFC says 80%!?!
Does anyone know how to properly calibrate the afc so that it reads 100% when the door in the maf is fully open?
01-14-05, 12:22 AM
#2
Attack Gas Station!!!!
Join Date: May 2004
Location: Catonsville, Maryland
Posts: 1,081
Likes: 0
Received 0 Likes
on
0 Posts
A few other people had the same issue...
They reset their afc's and the problem worked itself out..
make sure to set the vehicle type correctly.
~goodluck
suds
They reset their afc's and the problem worked itself out..
make sure to set the vehicle type correctly.
~goodluck
suds
01-14-05, 08:09 AM
#4
Attack Gas Station!!!!
Join Date: May 2004
Location: Catonsville, Maryland
Posts: 1,081
Likes: 0
Received 0 Likes
on
0 Posts
Maybe it's still not holding the settings?
Only other thing I can think of is that maybe the afm isn't sending the full range of signal to the ecu? unlikely, but in the factory shop manual, there is a diagram for all the pinouts on the ecu and their voltage ranges. (page 81-83, don't remember which section exactly.)
suds
Only other thing I can think of is that maybe the afm isn't sending the full range of signal to the ecu? unlikely, but in the factory shop manual, there is a diagram for all the pinouts on the ecu and their voltage ranges. (page 81-83, don't remember which section exactly.)
suds
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM
rx8volks
Canadian Forum
0
09-16-15 09:07 PM
rx8volks
Canadian Forum
0
09-01-15 11:02 PM
