Wolf 3D install and tuning in Houston?
#1
Administrator
Thread Starter
Wolf 3D install and tuning in Houston?
As the title says anyone in Houston ever setup or tuned a Wolf 3D here in Houston (or nearby)?
FYI - This is on a Turbo 2
FYI - This is on a Turbo 2
#4
Red Neck Tony Stark - C2
iTrader: (1)
Well if you cant find anyone to install it, I have more than enuff wiring under my belt.
Hay Keith check out my new toys i am selling
https://www.rx7club.com/showthread.p...2&page=1&pp=15
I my give one away at are Christmas Meeting for one of the Prizes.
Hay Keith check out my new toys i am selling
https://www.rx7club.com/showthread.p...2&page=1&pp=15
I my give one away at are Christmas Meeting for one of the Prizes.
#5
Administrator
Thread Starter
I have figured out that one of the key areas is to heat sheild the loom wires. Seems that many people overlook this crucial step and end up cooking the harness.
#6
Need more sleep
iTrader: (1)
I emailed spicracer, he used to run a Wolf on his third gen. If he can give me enough direction on the ins and outs of the ecu install I may be able to help you Keith, tuning it should be a snap. My only concern is the crank angle sensor calibration if it is not a bolton or plug and play affair.
Trending Topics
#10
Administrator
Thread Starter
Kyle,
Did you ever get any info back from Carlos, I'd like to get started on this project and enjoy it a little before this beautiful weather goes away. Thanks, DKJ
Did you ever get any info back from Carlos, I'd like to get started on this project and enjoy it a little before this beautiful weather goes away. Thanks, DKJ
#11
Red Neck Tony Stark - C2
iTrader: (1)
Hey Keith, I have that FD Igniter that you will need.
Also I have been looking for a Ignition amp for myself and i have learned that the MSD DIS-2/DIS-4 that you have will not work for a rotary. The fire events happen to fast for the box to spark the Leading and Trailing right after each other, what i am told is it needs at least 40 degrees between spark events.
I would just use the Stock coils and the FD igniter.
If you can find someone that can set it up i will finish the wiring for you. I still dont understand how to upload the map to it.
Also i modded a CAS for your car, the way that it is wired right now will work but isnt the best from what i have heard, so I have the CAS for it.
Also I will be off Wed and Thrusday i may try to drop by early thrusday to finish up the coil stuff. But i am kinda at a lost on the map loading.
Also I have been looking for a Ignition amp for myself and i have learned that the MSD DIS-2/DIS-4 that you have will not work for a rotary. The fire events happen to fast for the box to spark the Leading and Trailing right after each other, what i am told is it needs at least 40 degrees between spark events.
I would just use the Stock coils and the FD igniter.
If you can find someone that can set it up i will finish the wiring for you. I still dont understand how to upload the map to it.
Also i modded a CAS for your car, the way that it is wired right now will work but isnt the best from what i have heard, so I have the CAS for it.
Also I will be off Wed and Thrusday i may try to drop by early thrusday to finish up the coil stuff. But i am kinda at a lost on the map loading.
Thread
Thread Starter
Forum
Replies
Last Post
Claudio RX-7
Haltech Forum
5
04-23-19 02:50 PM