XS TO4E question?????
I'm debating on going with new twins (M2) or going with the XS TO4E kit. I'm going to be running it on a stock motor with 62K miles. I plan on keeping the boost around 12psi. The following mods will also be done:
-Power FC
-Greddy FMIC
-walbro FP
- stock primaries, 1300cc secondaries
-midpipe
-catback
-DP
-Boost controller
Will running the XS TO4E on my stock motor with these mods be ok for a while till i rebuild???? thanks guys
-Rick
-Power FC
-Greddy FMIC
-walbro FP
- stock primaries, 1300cc secondaries
-midpipe
-catback
-DP
-Boost controller
Will running the XS TO4E on my stock motor with these mods be ok for a while till i rebuild???? thanks guys
-Rick
go for the single, the twins suck.
in addition to the above mods, you will need 1300 cc secondary injectors, a fuel pump, ignition amplifier, and upgraded plugs and wires, and then dyno tuning. You should be fine after that.
in addition to the above mods, you will need 1300 cc secondary injectors, a fuel pump, ignition amplifier, and upgraded plugs and wires, and then dyno tuning. You should be fine after that.
Like said, get the single. I don't think you necessarily NEED and ignition amplifier but it wouldn't hurt. I don't have one yet, but will get one soon. But since you will be putting bigger injectors in you will need the fuel pump. I would recommend the Nippondenso Upgrade pump that rx7store sells. Very easy to install.
M-P
M-P
Thanx for the info guyz... yes, i am leaning toward the to4e kit. One question that still remains for me is it ok to run this setup on a stock motor with low boost...say around 10-14 psi until the rebuild??
-Rick
-Rick
Thread
Thread Starter
Forum
Replies
Last Post
Adaptronic S5 Turbo PNP Unit questions
_Tones_
Adaptronic Engine Mgmt - AUS
10
May 25, 2021 05:37 AM
Nosferatu
2nd Generation Specific (1986-1992)
7
Sep 5, 2015 02:13 PM



