Wiring Harness Question
#1
Full Member
Thread Starter
iTrader: (3)
Join Date: Jul 2006
Location: Mn
Posts: 177
Likes: 0
Received 0 Likes
on
0 Posts
Wiring Harness Question
I recently rebuilt my motor and also went single. Here are some of my questions-
1. What do you guys do with all the plugs that are no longer being used?
2. Are there any solenoids I need to use now? I am hooking up my own FPR.
3. I upgraded my secondaries to 1600's and I wanted to make sure these are the secondary plugs and my other question was which wire on the new fuel injector gets wired to which side on the plug?
Thanks
Jeremy
1. What do you guys do with all the plugs that are no longer being used?
2. Are there any solenoids I need to use now? I am hooking up my own FPR.
3. I upgraded my secondaries to 1600's and I wanted to make sure these are the secondary plugs and my other question was which wire on the new fuel injector gets wired to which side on the plug?
Thanks
Jeremy
#2
Will work for horsepower
Pull up the wireing diagram and it will tell you what color wire goes to witch injector ie secoundary 1 & 2 it should be in the search forum. And the stock plug will not work with the 1600's.
#3
Full Member
Thread Starter
iTrader: (3)
Join Date: Jul 2006
Location: Mn
Posts: 177
Likes: 0
Received 0 Likes
on
0 Posts
I know the old plugs wont work on the 1600's. i was wondering which wire on the current plug goes to which wires on my new injectors. I don't want to connect the wires backwards.
#4
Will work for horsepower
If you know witch plug goes were then it doesent matter witch wire goes were ground and signal could care less. A injector is a solinoid and does not have a + or - too simple ugh!
Thread
Thread Starter
Forum
Replies
Last Post
82streetracer
1st Generation Specific (1979-1985)
7
08-23-15 09:28 AM