what do you think about the fmic
#1
Senior Member
Thread Starter
Join Date: Mar 2004
Location: ava mo
Posts: 517
Likes: 0
Received 0 Likes
on
0 Posts
what do you think about the fmic
#2
Eats, Sleeps, Dreams Rotary
Originally Posted by snagalittle
Just fukin with you....I dont know..No brand name...You may want to see if anyone else has installed it...Biggest thing would be fitment issues and at what psi range you are shooting for and if it meets your requirements.
#5
Senior Member
Thread Starter
Join Date: Mar 2004
Location: ava mo
Posts: 517
Likes: 0
Received 0 Likes
on
0 Posts
I was just curious. I am going to save my money and go with the blitz fmic. I have a t51r kai that i am installing along with other mods. I have a stage three port job from rx7 store. SO i "hope" i can get it to spool around 4500. If not ill just run a shot of Nitrous through it. What kind of boost should i be able to run (with tuning) on 93 pump gas that motor turbo blitz fmic, and lots of other mods? I have 1300cc secondaries and 850 primaries. Of course fuel pump and aeromotive regulator. Oh and i have a pfc
#6
With an HKS turbo, it would be wise to have a HKS FMIC for the easiest bolt on installation. The prices are about the same between the Blitz and HKS.
I'd say you should be able to run around 17lbs or so, maybe more.
I'd say you should be able to run around 17lbs or so, maybe more.
#7
Rotary Freak
Join Date: Mar 2003
Location: GLENDALE, CA
Posts: 2,274
Likes: 0
Received 0 Likes
on
0 Posts
i have the Blitz FMIC.... i like the concept that the IC sits further back so the radiator gets air too...
also, i know about that turbo kit also... first, its very very expensive... then, it will start spooling at around 4k rpm and you will have full boost at around 6k.. give or take a few hundred..
also, i know about that turbo kit also... first, its very very expensive... then, it will start spooling at around 4k rpm and you will have full boost at around 6k.. give or take a few hundred..