I fitted resistors to my injectors, the setup ran without them before ok. i heard they needed them bought some. now when i crank the engine over it wont start.

the plugs are not wet at all im getting no cycle duty on my pfc hand controller. does this mean my injectors aint working? I am getting 40psi on my fpr guage tho

could this be something to do with the 2 crank sensors which i have rewired

or have i fryed my pfc?

any help please would be greatly appreciated, i really need this sorted. tomorrow. what else can i try

 

Is your tach bouncing slightly when your starting it? make sure your wire aren't backwards in the connector you replaced.

 

what injectors are you running? You can actually run 1600's without resistors...