single w/out PFC?????
#1
Run, Run, FD!!!
Thread Starter
Join Date: Feb 2006
Location: Argentina
Posts: 16
Likes: 0
Received 0 Likes
on
0 Posts
single w/out PFC?????
Hi everyone~~!?
I was asking my self....
What happends if you go single without a PFC???
- I mean, fuel lean/rich patterns
- idle
- sensors (since all solenoids are gone)
- how many boost will handle (if any)
wanting to know general opinion and of couse technical data~!
I was asking my self....
What happends if you go single without a PFC???
- I mean, fuel lean/rich patterns
- idle
- sensors (since all solenoids are gone)
- how many boost will handle (if any)
wanting to know general opinion and of couse technical data~!
#3
Originally Posted by heatdriver
Hi everyone~~!?
I was asking my self....
What happends if you go single without a PFC???
- I mean, fuel lean/rich patterns
- idle
- sensors (since all solenoids are gone)
- how many boost will handle (if any)
wanting to know general opinion and of couse technical data~!
I was asking my self....
What happends if you go single without a PFC???
- I mean, fuel lean/rich patterns
- idle
- sensors (since all solenoids are gone)
- how many boost will handle (if any)
wanting to know general opinion and of couse technical data~!
obviously the fuel curves and timing curves are going to be off, you might run lean on some areas, rich in others.. Just don't do it.
idle should be ok
sensors can be there with a single setup if you block off/re route them the right way.
but if you remove them, you'll have a lot of codes
boost is controlled by the wastegate
Thread
Thread Starter
Forum
Replies
Last Post
demetlaw
3rd Generation Specific (1993-2002)
6
10-02-15 06:22 PM