Slayers94rx7

I don't know if anyone ever asked this question, but I am running a non sequential setup and I am loving it. The only thing that I miss is always being able to hear my bov. I only hear the full woosh sound from the bov when I am under full boost. Before when I was setup sequential, I would here the bov just from pressure built up under vacuum. I would like to basically be able to hear my bov just from reving the engine. I know it sounds stupid, but I miss the sound. I remember cruising around and each time I shifted I got to hear the woosh sound. So, my question is, what would be a good single turbo to get, that would build up enough pressure at low rpm's to allow me to hear my bov again. Any suggestions would be helpful.

Thanks.

WaachBack

iTrader: (21)

Adjust your BOV.

Slayers94rx7

Adjusting it won't fix my problem. The pressure build up is not the same anymore once I went non sequential.

Turblown

iTrader: (12)

BB 57 trim To4E with a .84 or 1.0 t4 turbine housing...

Slayers94rx7

At what rpm's would I see the boost start to spool up?

ScorpionT

iTrader: (3)

Precision 6262 or GT35R.


BOVs dont work off pressure from the turbo, they are pulled open by manifold vacuum.

WaachBack

iTrader: (21)

With that turbo? In the low 3k range.