Single tub fitted but car wont start now
02-10-09, 01:25 PM
#1
The Sleeve
Thread Starter
Join Date: Apr 2006
Location: merseyside
Posts: 268
Likes: 0
Received 0 Likes
on
0 Posts
Single tub fitted but car wont start now
fitted to4r tub, kg rail with 1600s aeromotive, fuel pump
As above. it tries to start and misfires / bangs. now it wont even splutter for me. fuel pressure is about 14psi?
On my power fc the sensors are all ok. but PAC NTR AND CCN are black. pressure says .37 bar with only ignition on? has anyone got a clue what these mean
Took the plugs out and i dried em and cleaned em but still nothing.
Has anyone any ideas on this one?
Cheers
As above. it tries to start and misfires / bangs. now it wont even splutter for me. fuel pressure is about 14psi?
On my power fc the sensors are all ok. but PAC NTR AND CCN are black. pressure says .37 bar with only ignition on? has anyone got a clue what these mean
Took the plugs out and i dried em and cleaned em but still nothing.
Has anyone any ideas on this one?
Cheers
02-10-09, 01:35 PM
#2
The Sleeve
Thread Starter
Join Date: Apr 2006
Location: merseyside
Posts: 268
Likes: 0
Received 0 Likes
on
0 Posts
I know what those codes are for now so no worries there. should i change anything on the pfc before starting the car? like sequential disbled which ive done and should i initilaize all data ? im well puzzled i have fuel and spark and air but wont start now. argh
02-10-09, 04:47 PM
#4
The Sleeve
Thread Starter
Join Date: Apr 2006
Location: merseyside
Posts: 268
Likes: 0
Received 0 Likes
on
0 Posts
i have an aeromotive fpr, the vdo gauge after trying to start it says about 14 or 15, not sure when im actually cranking it over tho. will i have to get someone to watch it while im turning the engine over?
Thread
Thread Starter
Forum
Replies
Last Post