Is the side port of a Wastegate supposed to hold pressure?
#1
Is the side port of a Wastegate supposed to hold pressure?
When I apply pressure to the side port of my 44mm Tial the valve opens at the proper pressure, but then it closes as the pressure is maintained. I found some information that the seal around the valve shaft isn’t supposed to seal perfectly, but what is normal? I would think that in a perfect system, it would not leak any pressure. Are other WGs the same (JGS, Synapse, etc)?
Thanks.
Thanks.
Thread
Thread Starter
Forum
Replies
Last Post
CaptainKRM
2nd Generation Specific (1986-1992)
14
08-26-15 09:52 PM