RX6 Oil Inlet fitting needed bad!
#1
Full Member
Thread Starter
Join Date: Dec 2001
Location: Irvine
Posts: 143
Likes: 0
Received 0 Likes
on
0 Posts
RX6 Oil Inlet fitting needed bad!
Mine broke due to overtightning, just snapped. This is the oil inlet with a 10 mm 1.5thread to a -4 an fitting. This fitting also has the oil restictor jet on it, so it would be impossible to get at a hose shop. Please let me know if anyone has suggestions, etc.
Thanks,
Ravi
Thanks,
Ravi
#2
I did the same thing when I first installed my kit. just give apexi USA a call. hopefully they will have it in stock, otherwise you will have to wait for it to come from japan.
mike
mike
#5
Rotary Enthusiast
yup, apexkw had to order one through apex usa..... it sucked, took like 3 months and was such a hassle...... best thing to do would be to just get a normal earls fitting, have the top brazened up (welded) and then just drill a small hole in the weld the same size as the stock hole.... or try using a pill, that might work good too......
Thread
Thread Starter
Forum
Replies
Last Post
KAL797
Test Area 51
0
08-11-15 03:47 PM