pressure test question.....
#1
tom port.. AKA streetport
Thread Starter
iTrader: (6)
Join Date: Jan 2005
Location: ludlow, pa
Posts: 4,659
Likes: 0
Received 0 Likes
on
0 Posts
pressure test question.....
so i pressure tested my intake today up to 10LBS. using this
http://www.boostpro.net/prodtester.html
i also used soapy water.
when i started i couldnt get the gauge past 2lbs!!!
found all the leaks and stopped at 10LBS.
should i go higher?
im planing on running around 15LBS of boost so should i test up to 15?
http://www.boostpro.net/prodtester.html
i also used soapy water.
when i started i couldnt get the gauge past 2lbs!!!
found all the leaks and stopped at 10LBS.
should i go higher?
im planing on running around 15LBS of boost so should i test up to 15?
#2
7s before paint!!!
iTrader: (2)
I would test to at least what boost you plan on running if not a couple pounds higher. That way you can check and make sure all the connections are sound and avoid any problems. Just make sure you don't exceed the rating of the map sensor by much or just unhook it temporarily.
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM
ZaqAtaq
New Member RX-7 Technical
2
09-05-15 08:57 PM