Non-Seq Mod
#1
-----MYOLD7UPYOURS-------
Thread Starter
Join Date: Nov 2006
Location: wausau,wi
Posts: 95
Likes: 0
Received 0 Likes
on
0 Posts
Non-Seq Mod
I am doing the full non-seq mod for my 13bre turbos..I have read what it consists of and how to do it..My questions are...
(A) When I make the block off plate, where do I mount it to?
(B) How do I modify the exhaust manifold to accept the fully no-seq turbo?
(C) Do I need to do anything other than what I am asking about?
When I compare this turbo to my CT26 out of a Supra it looked realy small,and everyone said that 26 was too small for a rotary..Any how thanks for all the good help..I'd be lost without this place..lol.. Thanks again
(A) When I make the block off plate, where do I mount it to?
(B) How do I modify the exhaust manifold to accept the fully no-seq turbo?
(C) Do I need to do anything other than what I am asking about?
When I compare this turbo to my CT26 out of a Supra it looked realy small,and everyone said that 26 was too small for a rotary..Any how thanks for all the good help..I'd be lost without this place..lol.. Thanks again
#3
-----MYOLD7UPYOURS-------
Thread Starter
Join Date: Nov 2006
Location: wausau,wi
Posts: 95
Likes: 0
Received 0 Likes
on
0 Posts
Ok thanks for the link, it helps alot..I thaught that I had to completely remove the smaller turbo to make it a true non-seq system? Would the 13bre be the same with all the uim and lim block offs and caps as the rew? All the conversions I have read about deal with the rew motors.........
Thanks
Thanks
Thread
Thread Starter
Forum
Replies
Last Post
demetlaw
3rd Generation Specific (1993-2002)
6
10-02-15 06:22 PM