ok heres the deal

i completed the instal about 2 days ago

upon start up i make sure that everything was taken cared of like fuel,spark, and oil/coolant in the engine

well i crank and crank and nothing, but i charged up my optima bttery and started to sputter and fire finally

after i let it idle (horrible loping) i shut the car off, i notcied that there was a oil underneath my car i ws like WTF???

i traced it to the oil feedline on the block, it was semi loose

so i left it like that until today, i retightend that bolt and while i was in there installed a new set of plug wires (manecore)

those are a bitch to put on the plugs, so i go put everything together and crank the car and nothing.....

i here some sort off clickin' (sounds like when u are teting plugs out for spark)thinkin that the wires were not properly seated on the plugs

so i pushed and pushed and make sure all of them were on there snug, and still nothing.....

am i doin something wrong here???

please help

mike

 

Sounds like you got something wrong in putting the magnecor wires back on, check against pictures on the forum, or look at a shop manual. It should at least try to catch, also something to do is to check for fuel smell from the exhaust, if it's getting fuel, it's most likely the Ignition not the turbo...

 

check all your grounds, fuel pump ground got me alst time i took my car apart.

 

i think its the wires too

wel i know the connection to plugs but theres a slight gap inbetween the insulator and the previous mark left from stock plugs on the coil packs

does it slide all the way in???

thanx guys grouds are koo mang, and thanx guys that was fast!!!! i love this forum

mike

 

oo i had another question

what is the idle map to start with a single

i uplaoded another map tuned for 850's allarounfd but i got 550's and 1600's

i was thinkin about goin back to stock base map

any suggestions on that??

mike

 

Try to really get the wires on... some times, if you don't push hard enough, they don't pop onto the plugs

 

Are you in Lancaster? They say 2 heads are better than one. I'd be glad to come take a look.

 

im in palmdale mang

pm me and we can meet up

mike

 

koo got it guys

mike

 

what was the problem?

 

well loose wires to coils

now i got an oil leak from block (oil feed line)

 

Same thing happend to my T04Z install. I replace mine with SS line. so you should do that too