na to turbo2
#1
Junior Member
Thread Starter
Join Date: May 2007
Location: USA ,GA ,smyrna
Posts: 6
Likes: 0
Received 0 Likes
on
0 Posts
na to turbo2
i have a problem i both a 88 rx7 that use to be na but was swap for a 91 13b turbo2 engine and it wont star i had some people see it but they say its the ecu or the mas air flow sensor or the hardness but the ecu and the mas air flow sensor are the turbo2 ones so i need to know what is require for this swap so i can get this car runing.
#2
Moderator
iTrader: (3)
welcome to the board.
first off, a bit of friendly advice, pay closer attention to your writing/typing. it's a bit hard to follow and that can be offputting to people that may otherwise help.
anyway, from what i think you said, you bought this car that already had the T2 motor in it. is that right?
the first question is has it EVER run since the engine swap? next question is how much of the basics have you confirmed (fuel, spark, compression, etc.)? did the person swap the whole harness or did they try to "make the original work" with the T2 ECU? the more info you can provide, the better.
first off, a bit of friendly advice, pay closer attention to your writing/typing. it's a bit hard to follow and that can be offputting to people that may otherwise help.
anyway, from what i think you said, you bought this car that already had the T2 motor in it. is that right?
the first question is has it EVER run since the engine swap? next question is how much of the basics have you confirmed (fuel, spark, compression, etc.)? did the person swap the whole harness or did they try to "make the original work" with the T2 ECU? the more info you can provide, the better.
Thread
Thread Starter
Forum
Replies
Last Post