-=Lil Red=-

iTrader: (24)

i have an 87 N/A, im doing the T2 swap and i want to rewire the walbro fuel pump.

i have the 2 resistor/relay from the stock T2, but where is the one on my N/A? i have read the instructions how to wire it, but where is my stock N/A fuel pump relay? do i have to cut it and use the 2 new ones? or leave it alone, i dotn even know whre it is?

is it by the passenger side head light cover?

-=Lil Red=-

iTrader: (24)

nodbody can help me ?

faster7

I'd be skipping the TII fuel pump wiring install altogether if you're wanting a "rewired" setup feeding the wallbro.

Run a healthy 10-12ish gauge fused power lead back to the strut tower or under a storage bin. Put a good ~15A-25A relay there, triggered by the stock fuel pump wire. Run new power to fuel pump from the relay. I'd tie the stock fuel pump ground wire to a good chassis ground, and come off that same ground for the new fuel pump ground.

-=Lil Red=-

iTrader: (24)

is there a way u can draw a diagram of how i can wire all of this please? thanks so much.

cezonetheillest

https://www.rx7club.com/attachment.p...achmentid=67856
rewire diagram

check this out also

https://www.rx7club.com/showthread.p...=tII+fuel+pump