My New 60-1 / Custom manifold!
Thread Starter
Joined: Sep 2001
Posts: 932
Likes: 0
From: Altadena, CA
Hmm... thanks for pointing that out, I somehow managed to completely forget all about it...
I guess i'll have a look tomorrow morning! <fingers crossed>
Aside from that, I've got the angle the front of the flange down a bit more (about 1/4") in order to give me decent smog-pump clearance. It will also make the downpipe a bit easier / cleaner.
Oh, BTW.. Does anybody have a good source for inexpensive U-bends? I'm looking for 2.5" mild steel (IC piping) and 3" mild steel (rework the DP). The cheapest ones I can find are like 25 each. It's not ridiculous, but it seems a bit pricey
Thanks!,
Manolis
I guess i'll have a look tomorrow morning! <fingers crossed>
Aside from that, I've got the angle the front of the flange down a bit more (about 1/4") in order to give me decent smog-pump clearance. It will also make the downpipe a bit easier / cleaner.
Oh, BTW.. Does anybody have a good source for inexpensive U-bends? I'm looking for 2.5" mild steel (IC piping) and 3" mild steel (rework the DP). The cheapest ones I can find are like 25 each. It's not ridiculous, but it seems a bit pricey
Thanks!,
Manolis
Thread
Thread Starter
Forum
Replies
Last Post
Clacor
Single Turbo RX-7's
19
Sep 11, 2015 08:36 PM
