Manifold tube diameter
#1
Full Member
Thread Starter
Join Date: Nov 2007
Location: NJ
Posts: 117
Likes: 0
Received 0 Likes
on
0 Posts
Manifold tube diameter
1) I am going to be building a long runner manifold in SS and was wondering if these would be good from mcmaster-carr- www.mcmaster.com/#43645k315/=24ofga. They are schedule 10 ss with a 1.68 id. Would this be large enough for a streetported motor with a BW s361 looking to make ~400whp? Also should I get them in 304 or 316 (I will only be tacking them)?
2) I am also making a new downpipe/wastegate pipe and am going to ad another muffler to my exhaust. I was wondering if it is possible to use diesel style exhaust flex pipe to connect exhaust components after mounting them. Are there performance/exhaust tone drawbacks?
thanks
2) I am also making a new downpipe/wastegate pipe and am going to ad another muffler to my exhaust. I was wondering if it is possible to use diesel style exhaust flex pipe to connect exhaust components after mounting them. Are there performance/exhaust tone drawbacks?
thanks
#6
Full Member
Thread Starter
Join Date: Nov 2007
Location: NJ
Posts: 117
Likes: 0
Received 0 Likes
on
0 Posts
viking did they custom make that for you.. I remember you were trying to make your own mani. This is the manifold I saw that made me think I only needed 1.5 schedule 10
Trending Topics
#9
Full Member
Thread Starter
Join Date: Nov 2007
Location: NJ
Posts: 117
Likes: 0
Received 0 Likes
on
0 Posts
So is smaller diameter faster spool? Right now I have 2 inch schedule 40 non stainless pipe which is 2.07'' inside diameter and I am not pleased with spoolup. Can someone just tell me the diameter of pipe on the manifold that comes with one of their gt35 kits?
Thread
Thread Starter
Forum
Replies
Last Post
Shainiac
Single Turbo RX-7's
12
07-17-19 02:20 PM