Just swapped motor now wont start
#1
Junior Member
Thread Starter
Join Date: Aug 2005
Location: Ireland
Posts: 33
Likes: 0
Received 0 Likes
on
0 Posts
Just swapped motor now wont start
Ok guys,
I'm just about finished fitting a new motor and greddy t78 turbo kit in my FD. Now she wont start. I've removed all solenoids including the double throttle control (the actuator on the back of the throttle body) was i right to do this. Ive checked that there is spark and there is fuel getting on to the plugs. the only thing i can think of is that i have the plug leads the wrong way round. i have the far left port on the coil pack going to top left plug,one of the 2 middle coil packs going to bottom left plug other middle to bottom right plug far right coil going to top right plug.any help appreciated as i need her going tonight .
I'm just about finished fitting a new motor and greddy t78 turbo kit in my FD. Now she wont start. I've removed all solenoids including the double throttle control (the actuator on the back of the throttle body) was i right to do this. Ive checked that there is spark and there is fuel getting on to the plugs. the only thing i can think of is that i have the plug leads the wrong way round. i have the far left port on the coil pack going to top left plug,one of the 2 middle coil packs going to bottom left plug other middle to bottom right plug far right coil going to top right plug.any help appreciated as i need her going tonight .
#2
Rotary Freak
Join Date: Jan 2002
Location: Overland Park, KS
Posts: 2,360
Likes: 0
Received 0 Likes
on
0 Posts
Your plugs are wired up fine. Have you thought that you might of flooded it by now? Is it stumbling at all? Have you tried starting with a little help from starter fluid?
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM
Azevedo
Other Engine Conversions - non V-8
26
03-01-19 09:19 PM