How much power would my engine make with these mods
Thread Starter
Junior Member
Joined: Jan 2013
Posts: 47
Likes: 0
From: australia
How much power would my engine make with these mods
Hi just wanted to know how much power should I be expecting to get with the following mods on my FD.
Bridge ported
Single turbo gt42
Plates and s5 rotors machined and balanced
Engine studded
Mazworx bigger throttle body
Proflow fuel rail 4x 1000cc injectors
4x Aem smart coil, 10mm leads
Micro tech lt10 ecu
3" dp and ss exhaust high flow cat
Vmount
Alloy radiator
Dual
Bridge ported
Single turbo gt42
Plates and s5 rotors machined and balanced
Engine studded
Mazworx bigger throttle body
Proflow fuel rail 4x 1000cc injectors
4x Aem smart coil, 10mm leads
Micro tech lt10 ecu
3" dp and ss exhaust high flow cat
Vmount
Alloy radiator
Dual
Joined: Aug 2004
Posts: 4,496
Likes: 1,484
From: West Coast
It is very hard to guess where the confortable point will be.
But always easiest to see the most limiting factor, in your case injectors.
the 4 x 1000cc at 90% ( and base fuel pressure of 40 )duty will let you put down anywhere from 400-500 wheel depending on final afrs.
Then after injectors, ( say you get 2000cc secondaries ) , then next limiting factor would be fuel octane.
the GT42 breaths up top in the boost range. What fuel will you have access to, water meth , race gas , e85
But always easiest to see the most limiting factor, in your case injectors.
the 4 x 1000cc at 90% ( and base fuel pressure of 40 )duty will let you put down anywhere from 400-500 wheel depending on final afrs.
Then after injectors, ( say you get 2000cc secondaries ) , then next limiting factor would be fuel octane.
the GT42 breaths up top in the boost range. What fuel will you have access to, water meth , race gas , e85
It is very hard to guess where the confortable point will be.
But always easiest to see the most limiting factor, in your case injectors.
the 4 x 1000cc at 90% ( and base fuel pressure of 40 )duty will let you put down anywhere from 400-500 wheel depending on final afrs.
Then after injectors, ( say you get 2000cc secondaries ) , then next limiting factor would be fuel octane.
the GT42 breaths up top in the boost range. What fuel will you have access to, water meth , race gas , e85
But always easiest to see the most limiting factor, in your case injectors.
the 4 x 1000cc at 90% ( and base fuel pressure of 40 )duty will let you put down anywhere from 400-500 wheel depending on final afrs.
Then after injectors, ( say you get 2000cc secondaries ) , then next limiting factor would be fuel octane.
the GT42 breaths up top in the boost range. What fuel will you have access to, water meth , race gas , e85
But I agree with everything natey says/follows up with. Fuel will be a big factor, both in amount and choice/octane rating.
Joined: Aug 2004
Posts: 4,496
Likes: 1,484
From: West Coast
I can't take any credit. I just copy-n-pasted RX7(613)'s reply from ralph's other identical thread.
https://www.rx7club.com/rotary-car-p...-mods-1110760/
https://www.rx7club.com/rotary-car-p...-mods-1110760/
Oh lmao, one of these, obviously.... Should have seen it from a mile away... Derp
can't even say it's a double post, looks like the copy paste got deleted about halfway down (he did mention the fuel pumps, lol)
Even the times are HELLA off... So yeh, I vote mods simply delete this one. ahah
can't even say it's a double post, looks like the copy paste got deleted about halfway down (he did mention the fuel pumps, lol)
Even the times are HELLA off... So yeh, I vote mods simply delete this one. ahah
Last edited by Jimmy2222; Feb 21, 2017 at 09:44 PM.
Trending Topics
Joined: Oct 2001
Posts: 6,279
Likes: 728
From: Florence, Alabama
assuming your setup is built and tuned correctly my first question deals w the ultimate limiting factor: the turbo
which GT42 do you have?
GT4294
GT4202
two very different animals and animals they both are...
GT4294 8.34 compressor area 7.527 turbine
GT4202 9.72 comp 7.527 turbine
GT4294 1230 CFM 640 rotary rwhp (side intake port only)
GT4202 1374 CFM 716 rotary rwhp (side intake port only)
you currently have fuel (gas) for 411 rotary rwhp at 11.0 AFR
most of your setup looks nice, you just need to complete the fuel system.
Howard
which GT42 do you have?
GT4294
GT4202
two very different animals and animals they both are...
GT4294 8.34 compressor area 7.527 turbine
GT4202 9.72 comp 7.527 turbine
GT4294 1230 CFM 640 rotary rwhp (side intake port only)
GT4202 1374 CFM 716 rotary rwhp (side intake port only)
you currently have fuel (gas) for 411 rotary rwhp at 11.0 AFR
most of your setup looks nice, you just need to complete the fuel system.
Howard