hey guys,
i picked up a new master power turbo today. its specs are

t4 undivided .68 exhaust housing with 3" v band.

4" inlet with 2.5" outlet with .70 on the compressor.

turbine wheel
exducer 2.30" or 58.5 mm
mayor 2.91 or 74.0 mm

compressor/wheel
exducer 2.40" or 61.0 mm
mayor 3.58' or 91.0 mm

im putting it on my series 6 fd that has only a basic of ports. i want to be able to achieve around 300-350 rwhp on low b0ost levels eg (7-10psi). i think this turbo will spool early due to its small exhaust a/r of .68.

can anyone give me anymore info on what to expect. by the way i will be getting it retuned running a microtech computer

 

i would think the .68 is too small for a rotary...just my .02

 

yeah i do agree with you,
but i didnt have a choice in it and it was a good deal if i use it or re sell it

 

re sell it and get a larger hotside

 

or why not just buy another hotside? If thats a ptrim then you can just buy a larger for not all that expensive.

 

do u guys think that the .68 could handel 300-350 rwhp with out any dramas?

 

Not sure.... a "O" trim .70 divided houseing will handle that much.

If you have a "P" trim wheel it should handle slightly more, if its in the same .70 divided config. Not sure what housings are available for the "P" trim other than the standard stuff, .84, .96, 1.15 etc.

kenn

 

O-trim wheel sucks *****. .68 housing is too small.