Hks tubular on 13bre in fc3s fitament
My application was to use the HKS SS Tubular "T04Z" manifold on a 13BT in an FC.
The wastegate runners end up really close to the edge of the front subframe- a cut/weld to the WG flange on the WG runners with a slight angle could correct for this and point it more toward the transmission.
On my set-up, I cut off the WG runners and put dual 44mm WGs right on the manifold where the runners started- close fit to the motor mount and subframe, but I got it all to fit.
The manifold should fit the turbo to your 13BRE application as I believe the lower intake manifold is the same for fitment purposes as the 13BREW lower intake manifold.
The wastegate runners end up really close to the edge of the front subframe- a cut/weld to the WG flange on the WG runners with a slight angle could correct for this and point it more toward the transmission.
On my set-up, I cut off the WG runners and put dual 44mm WGs right on the manifold where the runners started- close fit to the motor mount and subframe, but I got it all to fit.
The manifold should fit the turbo to your 13BRE application as I believe the lower intake manifold is the same for fitment purposes as the 13BREW lower intake manifold.
