Finally ordered the kit today
#1
Ee / Cpe
Thread Starter
Join Date: Jan 2003
Location: Gaithersburg, MD / WVU
Posts: 2,843
Likes: 0
Received 2 Likes
on
2 Posts
Finally ordered the kit today
well the engine is out and no way am i putting that dog of a twin setup back in (flame suit on)
heres the list of parts i got:
New stage 2 ported motor
HkS cast manifold
HkS standard wastegate with .4bar spring (thinking about getting a stiffer spring in the future but ill see how i like it)
rx7store 1600cc, rail, regulator, pump, resistors ect kit.
block off plates
airpump remove pully
already had the t61 turbo
also ive gotta get the dp and intercooler pipes fabbed. and still gotta order a clutch
Im not forgetting anything other than depends am i?
2.5 weeks and counting
heres the list of parts i got:
New stage 2 ported motor
HkS cast manifold
HkS standard wastegate with .4bar spring (thinking about getting a stiffer spring in the future but ill see how i like it)
rx7store 1600cc, rail, regulator, pump, resistors ect kit.
block off plates
airpump remove pully
already had the t61 turbo
also ive gotta get the dp and intercooler pipes fabbed. and still gotta order a clutch
Im not forgetting anything other than depends am i?
2.5 weeks and counting
#3
Ee / Cpe
Thread Starter
Join Date: Jan 2003
Location: Gaithersburg, MD / WVU
Posts: 2,843
Likes: 0
Received 2 Likes
on
2 Posts
ive got about 50,000 boost controllers and bov's (nice thing about working for a manufacturer)
3 bar map sensor is already installed (haltech)
the fuel pump is coming with the fuel upgrade kit.
my exhaust gaskets look fairly new (less than 20k)
Im gonna do all my lines in aeroquip an cause i get a great deal on them through a friend, can anyone tell me whta fittings and lengths of line i will need for the oil lines? again its a garrett turbo.
which other gaskets will i need?
3 bar map sensor is already installed (haltech)
the fuel pump is coming with the fuel upgrade kit.
my exhaust gaskets look fairly new (less than 20k)
Im gonna do all my lines in aeroquip an cause i get a great deal on them through a friend, can anyone tell me whta fittings and lengths of line i will need for the oil lines? again its a garrett turbo.
which other gaskets will i need?
#4
Tony Stewart Killer.
iTrader: (12)
i can sell you an oil feed line and fittings for the turbo if its the same as mine i have a couple spares
pm me if you want
I went through the fuel system and replaced every o ring. also i took off everything on the engine and if it had a gasket i replaced it
for the oil drain line youll want to just find the right size ss hose to go from the turbo to the block. im using both oil drain lines even though I have just 1 turbo
pm me if you want
I went through the fuel system and replaced every o ring. also i took off everything on the engine and if it had a gasket i replaced it
for the oil drain line youll want to just find the right size ss hose to go from the turbo to the block. im using both oil drain lines even though I have just 1 turbo
Thread
Thread Starter
Forum
Replies
Last Post
rx8volks
Canadian Forum
3
08-20-15 10:24 PM
rx8volks
Canadian Forum
0
08-13-15 04:55 AM