sen2two

iTrader: (10)

I have my Holset now, and am getting rid of the eBay turbo set up finally. and i have a few questions...

are the oil feed and return flanges the same as other flanges? I dont have any handy to check...

Im going to rebuild mine before i install it. But i have never opened a holet. Any good write ups or how to on rebuilding them?

where to get a downpipe or the V band and flange to make my own down pipe? It has a 4" v band exit.

sen2two

iTrader: (10)

anyone?

sen2two

iTrader: (10)

oh, already got the down pipe. I was going to make my own. but got an aftermarket 4" downpipe. was made for Dodge 94-2002 Cummins. but fits nicely! cheaper than making it myself!!!

still need to know if these use standard type oil feed and return flanges. and i have rebuild a garrett before. But cant find any info on rebuild the HX40... any different?

SmogSUX

iTrader: (12)

I was going to go your route and buy one and rebuild myself, but ended up picking up one that was already rebuilt and balanced for I think $530...HX40, 19 cm^2 hotside, non wastegated..it was perfect..



Also I'd like to know what thread/pitch the feedline to turbo fitting is on the damn thing as well..

sen2two

iTrader: (10)

mine is also 19 cm^2 hotside. with the 4 " v-band exhaust.

i just noticed i need a new turbine blade (cold side). its not bad. but is has some defects on the blade. i would like a new one just to be sure...

where can you get all new parts?