I am looking for a clutch/pressure plate for a 400whp FD .... What do you guys suggest ???

and a single disc/puck clutch ... no twin disc

Thanks !!!!

 

Exedy Hyper Single seems to be popular

 

ACT 6-puck unsprung clutch disc with an ACT Extreme pressure plate. This combination is rated to over 400ft/lbs of torque.

 

do a search for exedy hyper single cerametallic. you will find lots of good info. i have about 8000 miles on mine.

howard coleman

 

This is what I purchased.

 

Get a sprung hub if you want to street drive it. I drove a 400 whp car with an RPS sprung 6-puck, which has plenty of capacity for that application, but it was very streetable.

 

I had the ACT 6 puck it grabs but it is too harsh for most. Exedy hypersingle is very nice for that power level.

 

I daily drove a 4 puck unsprung for about a year with ACT pressure plate and a stock flywheel. It did the trick, it was rough as all hell, but it sure grabbed!

 

I love my spec stage 3---sprung semi-met 6 puck.

 

I love my Pineapple Racing sprung hub 6 puck. It uses a more "friendly" material than the ACT models. CJ

 

I pretty much daily a 6 puck un-sprung in the summer, it's fine.. no problems, has some chatter sometimes though.

 

6 puck un sprung... extreem pplate. harsh but streetable and not tooooo bad. foot pressure is like a land rover clutch by comparison (old series IIs)

 

I'm still using the ACT street strip with extreme P plate and it has not slipped yet. I thought it would wear out immediately and have been surprised to see that not be the case.

 

+1 for act 6-puck extreme. I dont feel like i have a problem on the street with it. I actually like the feel of the clutch (I didnt used to though). You have to have a little finesse to street drive it smooth though...

adam

 

is that this one?

 

I know where you can find a Brand New RPS that will hold that kinda power.

 

thanks for the info !!!!!

 

Why FD ? You don't have a s5 engine ?