changing a flange on a SS manifold?
Thread Starter
Senior Member
Joined: Nov 2001
Posts: 579
Likes: 0
From: Qatar
changing a flange on a SS manifold?
is it too hard to change a flange on an RX6 manifold to a T4 flange type?
and would it crack. i'll not do the welding. i'll probably take it to a pro to do it.
i don't want the manifold to last forever, all i want is 1 year untill i can get a better manifold.
and would it crack. i'll not do the welding. i'll probably take it to a pro to do it.
i don't want the manifold to last forever, all i want is 1 year untill i can get a better manifold.
it should work as long as the welds are good but are you sure the new turbo is gonna fit on there ?? the apexi is small and you might need a small turbo to make it fit properly
Thread Starter
Senior Member
Joined: Nov 2001
Posts: 579
Likes: 0
From: Qatar
i'll run a 62-1 with a .96 hot side.
i did't buy the manifold yet but i'm assuming that since its a tubular manifold, the turbo should fit with no problems
i did't buy the manifold yet but i'm assuming that since its a tubular manifold, the turbo should fit with no problems
Last edited by zooq; Jul 19, 2003 at 02:50 PM.
Thread
Thread Starter
Forum
Replies
Last Post