14mm banjo to AN, is there one smaller than -6AN?
Thread Starter
Rebreaking things
Joined: Jun 2001
Posts: 2,586
Likes: 0
From: 1 foot in Boston 1 in NJ
14mm banjo to AN, is there one smaller than -6AN?
I know AtpTurbo makes a 14mm to 1/4." Does anybody know of a banjo fitting with a smaller outlet?
Last edited by CCarlisi; Jun 1, 2004 at 12:44 PM.
block-spike
Joined: Feb 2004
Posts: 548
Likes: 0
From: West Chester, PA
! stupid me it's .nethttp://batinc.net/main.htm
or call em at (941) 355-0005
Bob
out of curiousity ....what is this for anyway?
Last edited by rdavidsrx7; Jun 1, 2004 at 02:38 PM.
Thread Starter
Rebreaking things
Joined: Jun 2001
Posts: 2,586
Likes: 0
From: 1 foot in Boston 1 in NJ
Bob, thanks. I just called them and they have a 14mm bolt with a -4an fitting.
I am trying to put together an oil feed line for the turbo. I know I can connect a line to fitting at the end of the stock hardline, but I'm not crazy about the 'loop' of hose that is necessary to mate the line up with the angle of the input on the turbo.
Here is what I'm planning on doing instead:
14mm x1.5 to -4AN female
-4AN to -3AN
-3AN hose (with ends)
-3 AN to 1/8" NPT male
Thanks again for the contact.
I am trying to put together an oil feed line for the turbo. I know I can connect a line to fitting at the end of the stock hardline, but I'm not crazy about the 'loop' of hose that is necessary to mate the line up with the angle of the input on the turbo.
Here is what I'm planning on doing instead:
14mm x1.5 to -4AN female
-4AN to -3AN
-3AN hose (with ends)
-3 AN to 1/8" NPT male
Thanks again for the contact.
Thread
Thread Starter
Forum
Replies
Last Post
Wicked93gs
2nd Generation Specific (1986-1992)
42
Oct 7, 2015 11:58 PM
Kyo
2nd Generation Specific (1986-1992)
11
Sep 16, 2015 01:59 AM
