hi guys what turbo would be best from this place listed below to run on a 13b. I am building the motor and having the rear housing bridge ported and front housing half bridge port, i am running a microtech LT10S.
I am using the car for drifting and everyday but i am not worried how it drives on the road i just want it good for drifting.
http://www.pcpa.com.au/index.php?mai...=index&cPath=1

it is going on a this manifold
http://cgi.ebay.com.au/ws/eBayISAPI....ayphotohosting

 

Your statement of half bridge and full bridge doesn't make sense. You're either running a full bridge or a half bridge. Half bridging is running a bridge on the secondaries with ported primaries. I full bridge is running a bridge on both the primary and secondary ports.

 

if you are going to be drifting, that manifold isnt going to hold up without some serious bracing.

 

oh really why do they flex?
where and how would you brace it?


what about the tubo's guys? i was tossing up between these two?
http://www.pcpa.com.au/index.php?mai...&products_id=7
http://www.pcpa.com.au/index.php?mai...products_id=13