SE RX-7 Forum Serving the Carolina's, Georgia, Florida, Alabama, and Tennessee.
Sponsored by:

Tallahassee and surrounding areas.

Thread Tools
 
Search this Thread
 
Old Jun 6, 2012 | 12:08 PM
  #1  
NativeBeggars's Avatar
Thread Starter
Mountain Builder
Tenured Member: 10 Years
iTrader: (1)
 
Joined: May 2012
Posts: 616
Likes: 1
From: denvah
FL Tallahassee and surrounding areas.

Just wanted to get a roll call going for Tallahassee and the couple surrounding counties like Gadsden Wakulla, Franklin, etc. Let me know and we can get a legit rotary meet going here in town. Tired of seeing and getting invited to all these Busch-league meets full of ricers here in Tallahassee. Not going to happen. Lol

ROLL CALL:
Reply
Old Jun 8, 2012 | 08:21 AM
  #2  
evot23's Avatar
Classy
Tenured Member 10 Years
iTrader: (17)
 
Joined: Feb 2001
Posts: 6,900
Likes: 2
From: Gainesville, FL
bump to support the roll call
Reply
Old Jun 8, 2012 | 11:42 AM
  #3  
sharingan 19's Avatar
Rotary Revolutionary
Tenured Member 15 Years
iTrader: (16)
 
Joined: May 2006
Posts: 3,881
Likes: 3
From: Jacksonville, Tampa & Tallahassee
McDonalds on cap circle no longer the place to be on thursday nights?
Reply
Old Jun 9, 2012 | 10:28 AM
  #4  
NativeBeggars's Avatar
Thread Starter
Mountain Builder
Tenured Member: 10 Years
iTrader: (1)
 
Joined: May 2012
Posts: 616
Likes: 1
From: denvah
Hasn't been for a while honestly. I know TallyImports does their ricer meet at Milano's on thursdays off Tharpe, but that's not a car meet. There may be three real people there and only one rolls a 7. Also, I know this is the wrong thread, but I'm also looking for someone to help me get my 7 going. Bahah. It's got me stumped.
Reply
Old Jun 9, 2012 | 04:32 PM
  #5  
sharingan 19's Avatar
Rotary Revolutionary
Tenured Member 15 Years
iTrader: (16)
 
Joined: May 2006
Posts: 3,881
Likes: 3
From: Jacksonville, Tampa & Tallahassee
Thats unfortunate. When I was in tally there was a decent sized group of engineering students that would come out and actually knew something and drove cool cars. Come to jax, we'll help get the 7 goin lol
Reply
Old Jun 18, 2012 | 02:58 PM
  #6  
NativeBeggars's Avatar
Thread Starter
Mountain Builder
Tenured Member: 10 Years
iTrader: (1)
 
Joined: May 2012
Posts: 616
Likes: 1
From: denvah
I may be able to do that. I just would have to tow it there and have someone along with me to drive it and the tow vehicle back. I don't really have anywhere in Jax I can stay though, and I'm kinda broke at the moment because I'm about to start a new job, but if someone knows of a good cheap place to stay temporarily and a place to store/work on the car, I would definitely be down. I really do need to get it running ASAP though, so any suggestions would be great. Or if anybody knows of anyone with a good bit of rotary experience IN Tallahassee, PLEASE send them my way or a way I can get a hold of them. I'm about to break down and buy an engine/tranny/ECU/wiring harness/iggy coil combo I found online and just swap the bitch in. But that is definitely worst case, and I don't want to do that and find out I just needed injectors or a fuel filter or something. :c
Reply
Old Jun 18, 2012 | 03:27 PM
  #7  
NativeBeggars's Avatar
Thread Starter
Mountain Builder
Tenured Member: 10 Years
iTrader: (1)
 
Joined: May 2012
Posts: 616
Likes: 1
From: denvah
Most of the kids now are punks with Z/G cars from my highschool that source their plastidip and VHT spray from daddy's money. They all have plenum spacers and washers in their exhausts to make them loud. It's honestly pathetic. There are a few great people out there, but only one that drives an RX7.
Reply




All times are GMT -5. The time now is 10:23 AM.