I email you guys yesterday and then found this turbo on your web site. It say's "excellent spool up and good for about 350" Do ypou guys carry a turbo that has the same spool up but good for just a little bit more? maybe 380- 400?

Thanks in advance

 

check out the GT35R, that should fit your bill nicely.

 

GT35R would be the one to go with.

 

Dual Ball Bearing GT35/GT40R Turbo assembly. T4 style inlet flange with Vband style exit. Large 60- 1 style compressor housing with 4.00 inlet and 2.50 or 3.00" outlet. Hi HP 4-6 Cyl applications. This turbo has a flow capacity of about 600HP.

This turbo says its good for 600hp. Since I will never be going over 380-400 would all that extra ability from the turbo just create more lag? Is there just nothing inbetween the Garrett GT2860RS and the GT35/GT40R ?

If there is the lag diffrence is substancial I would rather have 30-40hp less and have amazing reasponse. Any suggestions?

Im also assuming none of these are direct bolt ons right?

Your have to forgive me I don't know much about turbos ar rations or turbo flanges at all. Any light on the subject would be aprechated.

 

Those power numbers you gave are very different for rotaries, go with the GT35R, amazing response and the will fit the bill for your power goal.