I updated my Pocket logger software from the digital tuning site, then hot synched it and now there are logs in my palm that say there from an S4 NA ECU.?!?!?!?! I have an S4 TII.

When I open RX7 Logger on my palm and click view there are all these logs and when i click on the information button it says "P2l lookup failed" it then keeps going to the same screen so i keep clicking and then it will display a message showing the date, size, time, params, length, and ecu of a different log I guess.

But the weird thing is that it shows a different date than any logs shown on the palm, and these "ghost logs" are from an S4 NA ecu??

whats going on here??

I never had anything to do with logs from an NA...

I just updated to pocket logger v 2.00 is the the most current version?

 

I assume you installed it over the original version without deleting the original first..

When you ran it the first time, did it say "updating logs to V2"?

 

I think I originally installed the new version and then tried to hotsynch and it froze, then my palm got all messes up and reset it and emptied it and reinstalled the new version.

What should I do? I'll reinstall everything from ground zero again if need be, I was just really curious where the stuff about the NA ECU came from?

 

It sounds like for whatever reason, your logs were not updated to version 2. You will need to delete and reinstall the software. But upload the logs that were not updated. I want to see why they were not updated to 2.0.

 

Ok, I had this prob too. I uploaded the software for after purchasing 2.1. But My problem is that when I try to view a log I get a 'P2l lookup failed' (2 times and I press 'OK') and I cannot see the 'VR input' that I was trying to log? But the rest of the log is there?... Any Suggestions?