ok so i have a 2.1 rteck on my s4 tii.

i had a palm 3 to run pocketlogger off of. i had issue with it before saying P2I lookup failed while reviewing loggs.

i have about 16 logs that i have on my palm 3

i got a T3 palm just recently so i was sitting in my car with my palm 3 in my hand to review data log from previous day, i was going to program with t3 while looking at log on palm3

while i was loading the logs i had an error, it forced me to reset my palm3. so i did. but it still wouldnt pull up my VR analog which i have set up to show a/f ratio via wide band analog out


so..... i go out and datalog with my t3. i just got home and i just went to review my logs. when i clicked the look button it forced me to reset my palm tungston t3 device. so i did so....

when i went to review logs i got 2 errors of the same. P2I lookup failed. this screen popped up 2 times.

i went into my perameters and made sure i had the a/f or VR analog selected. it was.....

what should i do

 

Updating this helped my 'p2i lookup failed' issue.

www.digitaltuning.com/software/rtek.zip

Also see...

https://www.rx7club.com/showthread.p...ght=p2i+lookup

 

my VR imput works. it just wont pull up in saved logs.

i called pocket logger and they say there is a conflict with the old version clashing with the new version. saying to uninatall 2.1 and hot sync. then hot sink a 2nd time and reload 2.1

to cut out any chance. i'm going to do a hard reset on my palm and use a completely different computer with newly loaded palm software and the pocket logger program


when i installed my tungston t3 on my computer it asked me if i would like to transver palm III data on to my t3. and thats the problem i guess.

it has only been a problem since i upgraded. and you need to completely wipe out the old version first.