So I was checking my 02 sensor status on the diag screen it was reading RICH O2. When I went to check the voltage under the log screen, it was all kafloowy. RPM Was reading 98K, yes just under a hundred grand, Boost was fluctiating at about 5.6 PSI O2 went to 0.00

I fixed it by clicking to a different screen then back and it was back to reading normal. But as soon as i went back to daig, and then right back to log, it did it again.

I repeated this about 5 times.
This was all done with the engine at idle.

 

Hmm.. version of the logger software?

 

2.0.0 build 30.

 

The problem I believe is occuring only when you switch from/to/from the diag and log screens quickly. If you do the same procedure that you do to get it to fail, but wait 5-10 seconds between screen taps, does it still happen?

 

I'll have to check.

hey, did you see the one about my 5th gear switch? It seems backwards to me.