Rtek datalog rtek 2.1 3rd gear
#1
datalog rtek 2.1 3rd gear
finally been messing around with the data logging a bit. did a 3rd gear pull
airflow seems to peak right around 900 then I noticed I was going leaner as rpm increased past that point, I added some fuel in the high rpm areas, and these were the results.
does this mean the AFM is maxing out?
mods
rtek 2.1 walbro 255 720x1200 injectors, using arghx mild timing map.
street ported s4 block 8.5 rotors
greddy cast manifold and WG, straight dump
IHI rhc7 turbo, hks intercooler core, custom piping
"custom" 3" exhaust, though there is a 2.5" section in the center I need to get rid of...
have yet to get it on a dyno anywhere.
airflow seems to peak right around 900 then I noticed I was going leaner as rpm increased past that point, I added some fuel in the high rpm areas, and these were the results.
does this mean the AFM is maxing out?
mods
rtek 2.1 walbro 255 720x1200 injectors, using arghx mild timing map.
street ported s4 block 8.5 rotors
greddy cast manifold and WG, straight dump
IHI rhc7 turbo, hks intercooler core, custom piping
"custom" 3" exhaust, though there is a 2.5" section in the center I need to get rid of...
have yet to get it on a dyno anywhere.
#6
well **** somehow after reloading the map a couple months ago when I was having issues, it has switched back into load based timing! rechecked the option and it appears the map I had entered is still correct. desided to go in and remove a bit of high boost timing just incase of overboosting.
Thread
Thread Starter
Forum
Replies
Last Post