Tial 60mm gate springs
#1
pushing s##t up hill
Thread Starter
Tial 60mm gate springs
im wanting to know if i can get bigger springs for the tial 60mm gate, the website only lists 1 bar max, but my delema is im looking to do 40 psi ,
if all is well with my exhaust design, is the 1 bar springs enough
Ive searched but found many threads similar but not specific enough
if all is well with my exhaust design, is the 1 bar springs enough
Ive searched but found many threads similar but not specific enough
#2
pushing s##t up hill
Thread Starter
haha sorry i don't mean to say i want 40 psi of springs in my wastegate, just somewhere in the low to mid 20s would be better as my low boost im looking to be off the gate pressure minimum spring zone , i dont want gate creep as a factor
#4
pushing s##t up hill
Thread Starter
we tried that on our other car and it was too violent on the opening and closing of the valve, it just opened and dumped the inlet of air, flat spotted and then took off again, and it was a pulsation effect all the way , i suppose we would have had to try different pop valves for better/smoother control but fuckn too hard and not time we wish to waste when a simple exhaust gate is easily tuned
#7
pushing s##t up hill
Thread Starter
that was on our twin turbo PP setup with no exhaust wastegate just a 35mm gate on the inlet plenum , to be sure we are talking about the same thing mate
i dont think you would get that pulsing effect with a exhaust gate , and thanks enzo, i knew i should have asked you since i did buy it from you
i dont think you would get that pulsing effect with a exhaust gate , and thanks enzo, i knew i should have asked you since i did buy it from you
Trending Topics
#9
pushing s##t up hill
Thread Starter
cool thanks mate, that would be my first gear launch boost though, as im then planning to feed it in more and more on the Eboost down the track , and that is when i thought it may be a bit iffy on the two blue springs that i have as well .
Time will tell , if it dont work there is a way to fix anything i suppose
Time will tell , if it dont work there is a way to fix anything i suppose
Thread
Thread Starter
Forum
Replies
Last Post
eplusz
General Rotary Tech Support
15
10-07-15 04:04 PM