My 1983 Pa La Fiebre
10-20-07, 12:43 PM
#1
Full Member
Thread Starter
My 1983 Pa La Fiebre
THIS ARE SOME PICTURES OF MY PROJECT PA LA FIEBRE. HOPEFULLY WILL HAVE IT READY FOR NEXT YEAR SEASON TO TEAR THE TRACKS HERE IN EL PASO, TX.
10-20-07, 06:43 PM
#4
*** Bless The USA
iTrader: (8)
Join Date: Jan 2007
Location: Saint Louis / Illinois
Posts: 7,139
Received 0 Likes
on
0 Posts
I have two question for you.
Did you weld the crossmember into the rocker panels ? Or did you just weld it into the cage ?
Also, do you remember how long your control arms are from rodend hole to rodendhole ?
Did you weld the crossmember into the rocker panels ? Or did you just weld it into the cage ?
Also, do you remember how long your control arms are from rodend hole to rodendhole ?
10-21-07, 11:45 AM
#6
Full Member
Thread Starter
suspension
I purchased the cross member from chassie engeneering, and trimmed it to fit into the contour of the rocker panel but first had to trim from the back of the hump so the cross member fit snug to the original.
the bottom one is 17" with one end adjustable the top one i have to re measure but check the picture and let me know. all on this suspension is made on this shop im working in with the exception of the cross member.
10-21-07, 12:56 PM
#7
*** Bless The USA
iTrader: (8)
Join Date: Jan 2007
Location: Saint Louis / Illinois
Posts: 7,139
Received 0 Likes
on
0 Posts
Cool, Cool........... I've got the same style of crossmember but I got mine from www.chassisworks.com
I'll need to run my upper and lower control arms on the inside of the frame rails though cause I'll be running a pretty wide tire.
Nice project, I like it !
I'll need to run my upper and lower control arms on the inside of the frame rails though cause I'll be running a pretty wide tire.
Nice project, I like it !
Thread
Thread Starter
Forum
Replies
Last Post
scissorhands
New Member RX-7 Technical
0
09-16-15 01:25 PM
