Here is the flier. I plan to be there. I heard a certain rx3 was going to be there (7-8sec car). Should be some fun.

 

You don't have a link to the rules of the classes, do ya? Sounds like a nice road trip

 

yeah Ernie bring that car on down to the south ill take mine down there if you coming , im hoping when mine is finished it runs pretty close to yours , theres alot guys down in ga and sc that dont think these rotarys will run

 

http://importshowdown.com/index.php?...&id=4&Itemid=2

Note: Competition rules are enforced! If you plan to compete be sure you know the rules for the class you are running in!

Fall 2010 Classes

•Showdown
•Modified/Street
•AWD
•RWD
•FWD
•All Motor
Competition rules apply ONLY to competitions. Test and Tune passes can be made with any configuration or setup, and any modification that meets track safety requirements.

Showdown
Proudly sponsored by: Forged Performance





•Slicks allowed
•Tire Limits:
•Slicks allowed
•Factory Dash (must be mostly complete a few missing pieces is ok)
•Exhaust must angle horizontally away from motor, it can exit beneath the vehicle
•Fuel Cells Allowed
•Wheelie bars are allowed, but limited to a 10.5" tire
•Transmission swaps ok, must be 3 speeds or more



Modified/Street
Proudly sponsored by: ECM Tuning

•Single Power Adder
•Tire Limits:
•FWD: Full Slicks
•AWD and RWD: DOT Approved (must have stamp)
•Front half of interior, single seat ok
•Open/any exhaust allowed
•Fuel Cells must be 8 gals or more
•Engine/Transmission swaps allowed only within same make (Honda/Acura, Nissan/Infinity, Toyota/Lexus, etc)
•Must have at least 3 forward speeds
•Transmission swaps to out of mfg transmission is not allowed without coordinated engine swap.
•Current Tag required



FWD
Proudly sponsored by: JJ Spec

•Single Power Adder
•Tire Limits:
•DOT Approved (must have stamp)
•Front half of interior, including both front seats and carpeting. (a few missing pieces is ok)
•Rear exiting exhaust
•Fuel Cells are not allowed
•Engine/Transmission swaps allowed only within same make (Honda/Acura, Nissan/Infinity, Toyota/Lexus, etc)
•Must have at least 3 forward speeds
•Current Tag required




RWD
Proudly sponsored by: JDM Parts Garage

•Single Power Adder
•Tire Limits:
•DOT Approved (must have stamp)
•Front half of interior, including both front seats and carpeting. (a few missing pieces is ok)
•Rear exiting exhaust
•Fuel Cells are not allowed
•Engine/Transmission swaps allowed only within same make (Honda/Acura, Nissan/Infinity, Toyota/Lexus, etc)
•Must have at least 3 forward speeds
•Current Tag required




AWD
Proudly sponsored by: Holeshot Wheels

•Single Power Adder
•Tire Limits:
•DOT Approved (must have stamp)
•Front half of interior, including both front seats and carpeting. (a few missing pieces is ok)
•Rear exiting exhaust
•Fuel Cells are not allowed
•Engine/Transmission swaps allowed only within same make (Honda/Acura, Nissan/Infinity, Toyota/Lexus, etc)
•Must have at least 3 forward speeds
•Current Tag required




All Motor
Proudly sponsored by: Savi Graphics

•No Power Adders
•Tire Limits:
•Radials (drag radials ok)
•Front half of interior, including both front seats and carpeting. (a few missing pieces is ok)
•Rear exiting exhaust
•Fuel Cells are not allowed
•Engine/Transmission swaps allowed only within same make (Honda/Acura, Nissan/Infinity, Toyota/Lexus, etc)
•Must have at least 3 forward speeds
•Current Tag required




Rules That Apply to All Classes

•3, 4, 5, 6, or 8 Cyl Vehicles Only or those with Rotary motors.
•Note: This is a total cylinder count, any additional form of combustion engine or cylinder adds to the count.
•Any name plate (import or domestic)
•Vehicles must be street legal in all other aspects not specifically defined as allowed by rule such as, but not limited to: headlights (removal of one for air indication is allowed), cooling system, brake lights. This includes hoods, bumper covers (bumper removal ok).
•No Lexan except in Showdown class, no single piece front ends except in Showdown
•All classes except Showdown vehicle must carry a recently valid registration tag (current year or previous year i.e. expired is ok, 2+ years old is not).
•Wheelie bars are only allowed in Showdown class. Strictly forbidden in all other classes.
•Vehicles can be towed to the track in all classes, assuming other street ability requirements of that class are met
•Only one vehicle is allowed in one class. A driver my enter multiple vehicles and run multiple classes. However, there are no considerations made for delaying competitions to accommodate this.
•Factory frames, no significant frame replacement. No back halfing or tube chasis vehicles.
•Engine swaps, even to a different mfg of the chassis is allowed.




We reserve the right to modify competition rules at any point or make any judgement calls necessary to ensure a fair, balanced, and most importantly - fun day for everyone.

Definitions

Power Adders are Turbo, Supercharger, or Nitrous (injected). The number of allowed power adders includes any factory power adders. Meth/Alcohol Injection and Intercooler sprayers are NOT considered power adders. Any Nitrous system that injects into the intake (not sprays externally) is considered a power adder. If you wish to enter a class where you would be otherwise not be allowed for using nitrous (too many power adders for example), you MUSTremove the bottle completely from the vehicle.

DOT Approved Tires are defined as any tire that carries a manufacturers DOT approved tag, regardless of compound (radial or bias ply). Example: ET Streets

Radial Tires are defined as any radial compound tire. This can include aggressive tread patterns that are often referred to as 'drag radials'. These are allowed in all classes.

Rear Exit Exhausts are defined as piping that runs the full length of the vehicle and exits behind the rear wheels. There are no checks for mufflers or cats.

Interior Requirements are defined as the basic required interior pieces. Showdown only requires a factory dash, all other classes require front half of interior with both seats and carpet. Individual missing pieces are allowed, as long as there is no obvious stripping of these locations. Replacement or removal of factory pieces to accommodate gauges and electronics are also allowed.

 

Ernie, bring Ray down with ya!!!!!!!!!!! Would love to have him do more tuning on mine at the track!

Let me know if anyone is serious about coming. I hope to have my new tranny in for the event but if not I will run the stocker. Think I will run the RWD class but will wait and see what the modified/street class looks like.

 

Don't look like they allow my tranny in any class.

 

If you are serious about wanting to come I bet I can get a rule change made for you. Maybe not in RWD but atleast in Showdown or maybe modified street. Let me know.

 

Well all want to be as fast as Ernie T!



If the guys arent a believer just have them bring some cash and I know a certain rx3 in GA that will be glad to take there money! He should be at this event.