I have tried 5 times(includes installing/removing) and still no luck. The banjo fitting are the biggest piece of *****. On the rail there brass adapters on the ends, copper washer and the bonjo deal and bolt. To tighten the bolt enough to where theres no leak will not work. The bolt is harder than the brass adapter so what happens,hum, it rips the threads out(just my ******* luck).
Is there any other options I can go with? Even if I removed the banjo bolts it still leaves me with brass fittings.
Does anybody make a rail that does not use joints?

 

what rail are you using?

 

i think it a rp one not really sure. Is anyway else around this problem. I dont have alot of money(very poor) ant this moment. So I cant aford to throw away what im using and buy new of the same stuff. I guess i will go to the bolt place tommorow and see what all they have.

 

Try replacing the copper washers on the banjo bolt. There should be two of them.

 

do they make aluminum adapters?

 

Call Garfinkle he made the fittings for his fuel rail with out 90 degree bends. His rail came from RP in Texas .615 893 4469