turbo 6port gsl-se rotors
#1
Full Member
Thread Starter
Join Date: Jan 2004
Location: Kansas City, MO
Posts: 58
Likes: 0
Received 0 Likes
on
0 Posts
turbo 6port gsl-se rotors
i made a turbo kit for my 86 6port i am in the process of rebuilding it and stumbled on the fact that gsl-se's have 3mm. i was wondering if anyone has used them in a s4 motor and if they have, or if u can, can i use my ecentric shaft with my counter weights because i also heard they weigh a little more. anyone?
#5
Senior Member
IIRC the GSLSE rotors are heavier than the 86-88 ones.. Yes 3MM.. but they are heavier I believe.. you may be better off going with the stock 6-port rotors and just fresh seals and correct timing.. and not too radical boost.
Coure... if you run radical boost or timing.. the 3MM will do you no good either
Coure... if you run radical boost or timing.. the 3MM will do you no good either
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM
stickmantijuana
MoTeC
5
09-10-15 07:58 PM