Profec Spec II Settings for TII's
#1
Rotary Enthusiast
Thread Starter
Join Date: Sep 2002
Location: Statesboro, GA
Posts: 1,233
Likes: 0
Received 0 Likes
on
0 Posts
Profec Spec II Settings for TII's
Just installed a profec spec II into my 88 TII.
13BT streetported, intake, exhaust, and monster ported wastegate. just curious what everyone's settings are for a similar setup. i can't recall my current settings. it seems to work ok tho. i get the classic FD boost curve 10-8-10. need to fiddle with it more. i'll post my settings when i get a chance.
% DC
Gain
StartBoost
13BT streetported, intake, exhaust, and monster ported wastegate. just curious what everyone's settings are for a similar setup. i can't recall my current settings. it seems to work ok tho. i get the classic FD boost curve 10-8-10. need to fiddle with it more. i'll post my settings when i get a chance.
% DC
Gain
StartBoost
#2
Rotary Enthusiast
Thread Starter
Join Date: Sep 2002
Location: Statesboro, GA
Posts: 1,233
Likes: 0
Received 0 Likes
on
0 Posts
My Duty Cycle is set to : 40%
Gain is set at : 28%
Start Boost is set to : 32%
will still take some messing to get it just right. but i'm very pleased with it. it goes to 10 really fast then immediately falls to 8 and then right back up to 10 again and stays there.
Gain is set at : 28%
Start Boost is set to : 32%
will still take some messing to get it just right. but i'm very pleased with it. it goes to 10 really fast then immediately falls to 8 and then right back up to 10 again and stays there.
Thread
Thread Starter
Forum
Replies
Last Post
KAL797
Test Area 51
0
08-11-15 03:47 PM