PPREs new RX4 project ;)
07-31-12, 06:17 PM
#26
Senior Member
Join Date: Mar 2004
Location: USA, PA, Harrisburg area.
Posts: 309
Likes: 0
Received 2 Likes
on
2 Posts
If I am looking at that right that is a 5 peice E-Shaft with 6 bearing surfaces!!!! or those bearings/stat gears are a two piece unit that is removed and installed as it is assembled?
I would love to see a video of this motor being assembled almost as much as one of this motor in a car stretching its legs!!!!
and that exhaust is just pure beauty!
also it is odd that they havent shown us any pics of the center or end housings unless they are just standard bits and they figured we wouldnt be excited about them...
I would love to see a video of this motor being assembled almost as much as one of this motor in a car stretching its legs!!!!
and that exhaust is just pure beauty!
also it is odd that they havent shown us any pics of the center or end housings unless they are just standard bits and they figured we wouldnt be excited about them...
07-31-12, 10:46 PM
#27
Rotary Enthusiast
^^ you need to get out more and see that the system they used isn't new.
Eccentric Shafts
And yes the end plates are basically stock.
Still a massive well done the PPRE guys, cant wait to hear this thing on the dyno or drag strip
Eccentric Shafts
And yes the end plates are basically stock.
Still a massive well done the PPRE guys, cant wait to hear this thing on the dyno or drag strip
