Pop Off Valve?
Thread Starter
Rotary Enthusiast
Joined: Feb 2001
Posts: 898
Likes: 0
From: Right Here!
Pop Off Valve?
I am in the process of building up my TII.
I'm going to go with a Haltech, bigger fuel rail, CRISPEEDS manifold with 40mm wastegate, 720's down low, and 1600's up high. A T04E 60-1 a/r 1.15. ( I alreday have a Greedy FMIC and BOV with a Apex AVCR )
All this on a new stock J-Spec engine!
In the past, I have blown up 3 engines because of creep (16-17 PSI)
I want to avoid that with this engine if possible.
What is the best pop off valve and how does it affect you when it "pops"? How does your car act when it goes off?
I'm going to go with a Haltech, bigger fuel rail, CRISPEEDS manifold with 40mm wastegate, 720's down low, and 1600's up high. A T04E 60-1 a/r 1.15. ( I alreday have a Greedy FMIC and BOV with a Apex AVCR )
All this on a new stock J-Spec engine!
In the past, I have blown up 3 engines because of creep (16-17 PSI)
I want to avoid that with this engine if possible.
What is the best pop off valve and how does it affect you when it "pops"? How does your car act when it goes off?
On a long vacation
Joined: Feb 2001
Posts: 2,160
Likes: 0
From: Bay Area, CA, U.S.A.
You're not really going to have any problems with boost crrep because the wastegate you're getting is MUCH better than the stock wastegates. If you're worried about either your boost controller going haywire or your wastegate hoses popping off then the popoff valve would be ok to get. I've seen people get good results from the HKS popoff valve.
Thread
Thread Starter
Forum
Replies
Last Post
ls1swap
3rd Generation Specific (1993-2002)
17
Jun 3, 2024 03:25 PM
renjiv2
3rd Generation Specific (1993-2002)
57
Jan 25, 2024 03:34 AM